Rebuild Benditalia brake booster

Posted on 22 januari 2022 by Saintly

Beantwoorden

Finished rebuilding the brake booster. Zinc plated, cleaned and put together using some new gaskets.

Rear axle rebuild

Posted on 9 november 2020 by Saintly

Beantwoorden

Also still busy with the diff. It has been painted and many parts zinc plated. I lost most of the pictures I made when disassembling so it takes some time to figure out how it needs to go back together again.

The LH side has new bearings and seals and the backplate is back on. I am waiting on some more new parts, bearing kit for the RH side and new brake shoes. I also have new pinion seal, brake drums and one new hub (I destroyed a hub and drum during a failed attempt to remove them with the wrong puller).

When the other bearing kit is in I need to figure out how to shim the axles.

Rebuild brake- and clutch master cylinder

Posted on 6 oktober 2020 by Saintly

Beantwoorden

Cleaned, shot blasted, painted and rebuild with new pistons and seals. Need to order new filler caps for both.

Rebuild brake proportioning valve

Posted on 24 september 2020 by Saintly

Beantwoorden

Calipers and rear brake pistons finished

Posted on 9 september 2020 by Saintly

So it has been a while, busy with work, kids etc etc. but I’m still working on the car. Finished restoring the calipers. Pistons where too far gone so bought a new kit with seals, pistons and brake pad pins.

I was considering changing the brake system from single system to a double because of safety, but I’m going to keep it original as a single system. If I would change it it would require to replace some bits; other calipers and rear brake pistons with double brake lines, an extra proportioning valve, different brake master cilinder and offcourse all double brake lines. But as I said I keep it a single system as it is original.